Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Smith & Wesson 637-2

Discussion in 'Gunsmithing and Repairs' started by Dharr, Nov 16, 2006.

Thread Status:
Not open for further replies.
  1. Dharr

    Dharr Member

    Joined:
    Oct 23, 2006
    Messages:
    9
    Hello to everyone. I've really enjoyed reading and learning from this forum. This is my 1st post. I own a Smith & Wesson 637-2. Been fired about 100 times. I recently noticed that the trigger is scratching the frame at the rear of the trigger guard. 2 parallel scratches, 1 about 1/8 of an inch and the other closer to 1/4 of an inch. I've never noticed this on any other revolver. Is this common or do I have a problem. Other than that the gun is fine. Any advice will be most appreciated.
     
Thread Status:
Not open for further replies.

Share This Page