So I took the A2 sight post off of a PSA upper.

Status
Not open for further replies.

ezypikns

Member
Joined
Jul 16, 2004
Messages
1,336
Location
Dallas, Texas
And now I'm installing a YHM rail type gas block. Small problem. The gas block roll pin (and the roll pin hole in the gas block tube) are smaller than the hole in the YHM gas block.

Any suggestions?
 
Last edited:
You need the correct roll pin for the gas block, then you can drill the gas tube if necessary, may be easier to replace the gas tube.

But I thought the gas tube roll pins, and thus the holes for them in the gas block were standardized. I've swapped out a fair number and never ran into this issue.


Does your YHM gas block mount with set screws or the original taper pins?

I'd contact YHM, they may have drilled the hole too big.
 
I've got YHM folding front sight bases on a couple of guns that I pulled the A2 base off. And they used same tube and pin that came off, so I think calling YHM as mentioned above is best advice.
 
Status
Not open for further replies.
Back
Top