Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Stiff bolt question?

Discussion in 'Rifle Country' started by pwrstrkd, Jan 9, 2011.

Thread Status:
Not open for further replies.
  1. pwrstrkd

    pwrstrkd Member

    Joined:
    Sep 1, 2010
    Messages:
    120
    Location:
    NJ
    I have a ruger hawkeye in 300 win mag and right after I shoot it is very hard to work the bolt back. It is NOT hard to lift the bolt up which indicate pressure problems, so I am confused on what can cause this, because otherwise the bolt is butter smooth when operating any time other than right after a shot. It is new and I have only shot it a few times so I dont know if that can be a contributing factor. Any help would be great.
     
    Last edited: Jan 9, 2011
  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    You are re-cocking the striker after firing, and that takes some muscle to compress the stiff firing pin spring.

    Put some good grease on the cocking cam at the bottom rear of the bolt, and a dab on the action rails where the bolt lugs rub back & forth, and see if that helps.

    rc
     
  3. pwrstrkd

    pwrstrkd Member

    Joined:
    Sep 1, 2010
    Messages:
    120
    Location:
    NJ
    Thxs for the advice but how come its not like this when i dry fire it? It only stiffens when firing live factory rounds.
     
  4. jpwilly

    jpwilly Member

    Joined:
    Aug 10, 2007
    Messages:
    3,892
    Location:
    Phoenix AZ
    If I'm hearing you right, you lift the bolt and "Extraction" is difficult...I'm thinking it's a rough chamber, may need polished up so the brass doesn't stick in the chamber.
     
  5. pwrstrkd

    pwrstrkd Member

    Joined:
    Sep 1, 2010
    Messages:
    120
    Location:
    NJ
    How do I go about polishing the chamber? My concern is why does a brand new rifle need its chambered polished. Is this a common problem with new bolt guns? Thank you for the help
     
  6. crowderdog

    crowderdog Member

    Joined:
    Jun 30, 2009
    Messages:
    18
    Location:
    Indiana
    In my experience the factory 'out of box' rifles that I've worked on have had chambers that ranged from very well finished to extremely rough. There are a lot of factors that determine finish when a chamber is reamed. The solution I have come up with is to use very fine emery cloth in a slotted tip on a cleaning rod turned in a drill. Let the centrifugal force cause the cloth to contact the chamber walls while keeping the tool itself from making contact. This has produced fine results for me. In extreme cases I have turned brass lapping tools to fit the chamber, using prints, and hand lapped the chamber with polishing compound. Great care must be exercised when polishing a chamber as removal of material can result in an over sized chamber.
     
  7. HOOfan_1

    HOOfan_1 Member

    Joined:
    Aug 11, 2010
    Messages:
    4,698
    Location:
    Virginia
    don't know about the Ruger...but my Remington 700, my CZ 550 and my dad's 98 Mauser all cock on lifting the bolt, not pulling back.
     
Thread Status:
Not open for further replies.

Share This Page