Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Sun Devil Mfg.

Discussion in 'Rifle Country' started by CarolusIV, Jun 8, 2011.

Thread Status:
Not open for further replies.
  1. CarolusIV

    CarolusIV Member

    Joined:
    Feb 21, 2011
    Messages:
    11
    Location:
    Tempe, AZ
    Starting research on building my first AR. Been looking at mating a Sun Devil Mfg. lower with an Adams Arms gas piston upper. Haven't found too many reviews about Sun Devil's work, though, so I was wondering if y'all have anything to saw about them.
     
  2. madcratebuilder

    madcratebuilder Member

    Joined:
    Jul 15, 2007
    Messages:
    5,020
    Location:
    Northern Orygun
    Sun Devil makes very nice billet uppers and lowers. The lowers have a tension screw for a tight fit between upper and lower. Not necessarily mil-spec but top tier. They make slick side upr/lwr's also.
     
  3. X-Rap

    X-Rap Member

    Joined:
    Sep 23, 2006
    Messages:
    6,619
    Used their upper and lower for a build I did for my daughter, the colors are cool and I got a free float tube that matched the receivers.
    The gal in the office said they were in development of a larger reciever (30 cal) I intend to give that a try when and if it goes to production.
    Good stuff and I'd definately use them again.
     
Thread Status:
Not open for further replies.

Share This Page