Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Surface Prep for Synthetic Stock

Discussion in 'Gunsmithing and Repairs' started by blaisenguns, Mar 7, 2013.

Thread Status:
Not open for further replies.
  1. blaisenguns

    blaisenguns Member

    Joined:
    Jul 17, 2009
    Messages:
    453
    Hi guys, I am about to do a rifle in camo with dura-coat. I wanted to know if anyone had any hints on what one should do to prepare a synthetic stock for this finish. I read the instructions, and saw no meaningful info for synthetic stocks. I know I have to make sure it is free from dirt and grease and dirt, but do I have to sand it to rough up the surface? I would think that the stuff should bong really well to plastic.
     
  2. jak67429

    jak67429 Member

    Joined:
    May 24, 2006
    Messages:
    176
    Clean and degrease.
     
  3. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
  4. blaisenguns

    blaisenguns Member

    Joined:
    Jul 17, 2009
    Messages:
    453
    Thanks RC.
     
Thread Status:
Not open for further replies.

Share This Page