Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Tanfoglio Model BTA90

Discussion in 'Handguns: Autoloaders' started by aji, Jul 13, 2006.

Thread Status:
Not open for further replies.
  1. aji

    aji Member

    Joined:
    Jul 13, 2006
    Messages:
    62
    Recently purchased a Tanfoglio BTA90 with case and 2 magazines. Nice pistol, a little heavy but a good shooter. I have 2 questions.

    1. Will I be able to use 9mm JHP +P ammo or will I need to stay with standard pressure JHP?

    2. Am looking for replacement grips. Prefer wood but may need to settle with rubber. There is not a lot of information about this pistol around and it seems that parts are scarce.

    Any information especially regarding parts is greatly appreciated.

    Thank you
     
  2. Cliff47

    Cliff47 Member

    Joined:
    Jul 22, 2003
    Messages:
    799
    Location:
    Washington State
    I also own a BTA90, and have the following to say about it: Nice compact design, but due to any warranty/support I have kept my feeding of the little thing to standard pressure FMJ ammo. Grips should be the approximate dimensions of the TZ75/Series 88 'Government' semi-compact model. You may find that Hogue has some exotic wood grips in the inventory (or will make some up for you). Another source of grips may be found over at the CZForum, Omega, Hakan Pek and Viking are supplying gorgeous grips form a number of woods. Check them out. Site address is www.CZForum.com. Good shooting.
     
Thread Status:
Not open for further replies.

Share This Page