Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Ted Williams 300 questions

Discussion in 'Shotguns' started by clone, Jun 21, 2013.

Thread Status:
Not open for further replies.
  1. clone

    clone Member

    Joined:
    May 29, 2005
    Messages:
    520
    I acquired a TW 300 recently and upon dissembling it I noticed there is no o-ring or forearm spacers as shown in the Winchester 1400 schematic. Are they missing or did the TW 300 not have them? If they are missing, where exactly should they go?
     
  2. CajunBass

    CajunBass Member

    Joined:
    Jun 2, 2005
    Messages:
    5,631
    Location:
    North Chesterfield, Virginia
    I'm not familiar with the TW 300, but if the Winchester manual shows them, they're supposed to be there. The Winchester and TW were identical except for the finish and such.
     
  3. clone

    clone Member

    Joined:
    May 29, 2005
    Messages:
    520
    Anyone know where these parts are suppose to go? Without these parts being there I have no clue, and the schematic isn't specific.
     
  4. GCBurner

    GCBurner Member

    Joined:
    Nov 18, 2010
    Messages:
    1,853
Thread Status:
Not open for further replies.

Share This Page