Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Threading an AR-15 Noodle Barrel

Discussion in 'Rifle Country' started by Badger Arms, Sep 13, 2004.

Thread Status:
Not open for further replies.
  1. Badger Arms

    Badger Arms Member

    Joined:
    Jan 1, 2003
    Messages:
    3,738
    Location:
    Harnett County, NC
    I have a DPMS light contour barrel on my post-post and would like to get the barrel cut to 14.5" and a flash suppressor permanently installed. Can a lightweight barrel of this size be threaded successfully? Who can do the permanent welding portion of the job?
     
  2. Dave Markowitz

    Dave Markowitz Member

    Joined:
    Dec 24, 2002
    Messages:
    6,993
    Location:
    Plymouth Meeting, PA
    Is it lighter than A1 contour? If it's the same as an A1 barrel I don't see why not.

    ADCO Firearms seems to have a good rep for this sort of job.
     
Thread Status:
Not open for further replies.

Share This Page