Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Ti and High Temps

Discussion in 'NFA Firearms and Accessories' started by MtnCreek, Nov 5, 2012.

Thread Status:
Not open for further replies.
  1. MtnCreek

    MtnCreek Member

    Joined:
    Dec 8, 2010
    Messages:
    3,962
    Location:
    West GA
    Can I get some info on what the operating temp limit is on Ti suppressors please? Also, does a surface reading on the outside accuratly tell me what's going on inside the suppressor?

    Thanks!
     
  2. Zak Smith

    Zak Smith Moderator Emeritus

    Joined:
    Dec 24, 2002
    Messages:
    9,037
    Location:
    Fort Collins, CO, USA.
    Recommend keeping it under about 800 degrees. In testing we didn't see actual failures until 1200 F was sustained for some time, but the failures at that point were fairly catastrophic.
     
  3. MtnCreek

    MtnCreek Member

    Joined:
    Dec 8, 2010
    Messages:
    3,962
    Location:
    West GA
    Thanks for the info!
     
Thread Status:
Not open for further replies.

Share This Page