Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

tough, sharp big knives-fair prices

Discussion in 'Non-Firearm Weapons' started by Byron Quick, Jan 5, 2003.

Thread Status:
Not open for further replies.
  1. Byron Quick

    Byron Quick Moderator In Memoriam

    Joined:
    Dec 21, 2002
    Messages:
    6,482
    Location:
    Waynesboro, Georgia
    Y'all might want to check out this guy: Dale Sandberg at Eight Dollar Mountain Foundry http://www.edmfknives.com


    I've got one of the pattern #23 "tanto" with the A hilt. Al Thompson just spent a couple of days hacking on a fat lighter stump trying to dull it...he couldn't.

    Dale's work is not fancy just tough and sharp.
     
  2. JShirley

    JShirley Administrator Staff Member

    Joined:
    Dec 20, 2002
    Messages:
    20,877
    Location:
    Atlanta
    Good gear. Found out about 'em from an article in SOF several years ago.

    Dale's a fellow shooter, too, and an good guy. Expect a bit of a wait, but it's worth it.
     
  3. Byron Quick

    Byron Quick Moderator In Memoriam

    Joined:
    Dec 21, 2002
    Messages:
    6,482
    Location:
    Waynesboro, Georgia
    Dale works in a sawmill and uses sawblades for his knives. From the thickness he is using the huge circular saws. I think that's D2.

    If so, more folks should use D2, I've never owned a knife that sharpens as easily as this one and yet holds an edge so well under heavy use.
     
Thread Status:
Not open for further replies.

Share This Page