Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Trying to find Stevens Model 200 scope base and rings

Discussion in 'Rifle Country' started by PendletonCowboy, Mar 21, 2010.

Thread Status:
Not open for further replies.
  1. PendletonCowboy

    PendletonCowboy Member

    Joined:
    May 6, 2009
    Messages:
    17
    I just got a Stevens model 200 and need to find rings and mounts. Can anyone tell me if it is the same as the Savage model 10? I can't find the Stevens model 200 in any charts. Is a one piece mount better than a two piece?

    Thanks
     
  2. R.W.Dale

    R.W.Dale Member

    Joined:
    Oct 14, 2005
    Messages:
    11,375
    Location:
    Northwest Arkansas
    the Stevens 200 is the same as a POST accutrigger 10


    just to verify is the rear receiver ring flat on top or round?
     
  3. PendletonCowboy

    PendletonCowboy Member

    Joined:
    May 6, 2009
    Messages:
    17
    The receiver ring is round on the top. So i would be looking for anything for a Savage 10 short action round receiver/Accutrigger? Its a 22-250...
     
  4. R.W.Dale

    R.W.Dale Member

    Joined:
    Oct 14, 2005
    Messages:
    11,375
    Location:
    Northwest Arkansas
    this is my understanding
     
  5. benzy2

    benzy2 Member

    Joined:
    Apr 24, 2008
    Messages:
    2,386
    Yes the pre-accutrigger Savage has a flat section where the rear base would mount. The Stevens 200 and the Accutrigger Savage models both use the same round top.

    The Stevens 200 uses the milling for the trigger that is the same as the pre-accutrigger and the milling for the bases that is the same as the Accutrigger models. Some people call it a clone of the pre-accutrigger Savage action but it is really a hybrid of the pre and post accutrigger actions.
     
Thread Status:
Not open for further replies.

Share This Page