Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

USP 45 Expert: Trigger pull weight?

Discussion in 'Handguns: Autoloaders' started by BerettaNut92, Jan 13, 2004.

Thread Status:
Not open for further replies.
  1. BerettaNut92

    BerettaNut92 Member

    Joined:
    Dec 23, 2002
    Messages:
    9,724
    What's the weight of the trigger pull of the USP 45 Expert, and if it's below 4#, is there anything I can do to increase it, to say, 4.5# or so?
     
  2. 10-Ring

    10-Ring Member

    Joined:
    Dec 24, 2002
    Messages:
    12,037
    Location:
    California
    Skunky, mine was measured at 3 - 1/8 #'s ;) I guess you could increase that by replacing the trigger spring & hammer spring w/ stock weight springs.
     
  3. BerettaNut92

    BerettaNut92 Member

    Joined:
    Dec 23, 2002
    Messages:
    9,724
    Hmmm. OC requires that the SA be at least 4# :( :banghead:
     
Thread Status:
Not open for further replies.

Share This Page