Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

VEPR front sight post

Discussion in 'Gunsmithing and Repairs' started by blarby, Jan 2, 2013.

Thread Status:
Not open for further replies.
  1. blarby

    blarby Member

    Joined:
    Feb 25, 2011
    Messages:
    5,144
    Location:
    Calapooia Oregon
    After the first shoot today, I can tell the elevation is WAY off.

    I'm trying to figure out exactly what tool you might use to adjust this front sight post ?


    I'm fairly certain that adjusting the rear sight ramp to its highest setting, and still getting barely in the lower portion of the center circle from 50 yards is not normal.... But if it is, call me crazy.

    At the lowest setting, it puts me off the target completely at 50 yards- so I'm assuming i'm going to need to adjust the front post...

    VEPR in .308- looks like a threaded front sight post pin- but there is no/extremely limited access from the bottom, and the top 1/4 of the threaded pin is ground off on two sides, making it look like a paddle....but I cant get it to budge using a pair of needle nose, and don't want to break it !

    Any help'd be great !

    Thanks !
     
  2. blarby

    blarby Member

    Joined:
    Feb 25, 2011
    Messages:
    5,144
    Location:
    Calapooia Oregon
    NM !

    Did some looking around in the box, etc.

    Apparently the handy toolkit that came with the gun contains just the tool required.

    Boy, those com-bloc boyz know how to do it, lemme tell ya...


    " In soviet Russia- sight post adjusts YOU "
     
  3. Walkalong

    Walkalong Moderator

    Joined:
    Nov 20, 2006
    Messages:
    45,998
    Location:
    Alabama
    Closed at OPs request
     
Thread Status:
Not open for further replies.

Share This Page