Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Visual inspection methods for case head failure

Discussion in 'Handloading and Reloading' started by MGK, Jan 16, 2006.

Thread Status:
Not open for further replies.
  1. MGK

    MGK Member

    Joined:
    Dec 27, 2002
    Messages:
    29
    Location:
    Illinois
    Anyone found a good way to do visual inspections inside the case for head separations. I know about using a sharpened paper clip etc for investigating them. I guess I was looking for a cheap rigid borescope or similiar idea. Any thoughts
     
  2. lonniemike

    lonniemike Member

    Joined:
    Jul 2, 2004
    Messages:
    150
    By using a bright light source(like the sun) and holding the case to see the inside case wall while rotating the case, one may see the ring(partial or full). Best-o-Luck
     
Thread Status:
Not open for further replies.

Share This Page