Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Vz24 and K98 clones... Lesson learned..

Discussion in 'Rifle Country' started by Afy, Jun 29, 2008.

Thread Status:
Not open for further replies.
  1. Afy

    Afy Member

    Joined:
    Dec 31, 2006
    Messages:
    2,595
    Do not try and feed a cartridge dierectly in the chamber.

    You end up with the cartridge stuck.. and a bolt that will not close...

    Guess how I know this.:eek::eek:
     
  2. goon

    goon Member

    Joined:
    Jan 20, 2003
    Messages:
    7,246
    Yep, controlled round feeding.
    Mine will chamber that way, but I also think that there is something wrong with my extractor.
     
  3. Leif Runenritzer

    Leif Runenritzer Member

    Joined:
    Aug 27, 2006
    Messages:
    232
    Been there, done that.

    And maybe i'm just so lucky, but the safety might come stuck in the off stead. Fortunately, a specialist gunsmith installed me a new one at little cost.
     
  4. 86thecat

    86thecat Member

    Joined:
    May 31, 2007
    Messages:
    207
    Location:
    Central WA
    Just sold a vz24 Brno in 30-06 which had the edge of the extractor slightly radiused, pushing in firmly on middle of the extractor would allow it to slip over the head.
     
Thread Status:
Not open for further replies.

Share This Page