Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Weaver V22-A Help

Discussion in 'Shooting Gear and Storage' started by FightingWombat, Jun 25, 2009.

Thread Status:
Not open for further replies.
  1. FightingWombat

    FightingWombat Member

    Joined:
    Dec 22, 2008
    Messages:
    16
    Location:
    longmont, co
    I just bought a Weaver V22-A, it has single price rings but the rail mount plate and screw are missing. If I cant find a replacement plate and screw, Has anyone seen any rings for 7/8" tube, I haven't found any. Also how do i get a ring in between the turrets and the end bell?
    -Thanks
     
  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    That is an old obsolete cheap scope, last made 25 or more years ago.
    The only parts available will probably be found in a junk box at a gun show.

    7/8" rings are also a thing of the past, and again, a gun show would be your only hope of finding a pair.

    The turret and rear lens assembly of your scope must be removed in order to get the sheet metal Tip-Off mount off in one piece.

    Best bet is to take all the screws out and bend it open far enough to get it off.

    In reality though, you would be better off to go to Wallyworld and buy a cheap Bushnell .22 scope.

    rc
     
Thread Status:
Not open for further replies.

Share This Page