Discussion in 'Handloading and Reloading' started by horsemen61, Jan 7, 2018.
30 300 blk out with h110 for my 8 inch ar pistol.
I finally finished up case prep on my 30-06 cases. De capped, sized, trimmed. One at a time, one by one I don't even know how many. I think about 3 gallons.
Thanks for the tip. I have a can of air to be used for cleaning off the press. I used dry lube under shell plate but might add a little grease.
In the morning finished loading some test rounds (9mm). In the afternoon shot them through the chrono to see which were performing most consistently.
Loaded 200 rounds 38 Special 158grain Semi wadcutters. 3.8 grains of 231
I can't even begin to think of how many pounds of 231/HP38 I've burned over the years with this combo.
Tossed a couple hundred 10mm cases in the tumbler.
Pull them out after dinner.
First attempt at PC using HF white (all I could find locally). The pigment is splotchy but the gloss covers everything. If they don't lead it works for me.
If you are using plastic BB/tub method in higher humidity conditions, rubbing the tub on carpet to increase static electricity improves PC coverage/thickness - https://www.thehighroad.org/index.p...-for-powdercoating.753510/page-3#post-9503527
I love that combo it just shoots sweet and new shooters that go with me I usually let them run those through our GP 100 it’s one of my my wife’s favorites as well.
Tested some low power .44 mag for my M69. Okay, now let's load up 500 of them.
OOOPS. I only got 150 pieces of brass. Duh.
Red seems to work the best. I have been using an old tumbler with powder to coat.
Same for me, but different in the fact that I have to cast bullets. Have 500 primed cases ready to load, but only 150 bullets............
Oh well...............I'll get to it when I do
After shooting I cleaned the Ruger 22/45 third whatever.
Next time I will stick with the Buck-Mark
100 357 magnums with varying charges of Accurate #9. Hopefully they work pretty good. Then knocked out 200 230gr 45 Acp loaded with True Blue, with a load I know works good.
Loaded around a hundred .223 plinking rounds.
I need to get to the range and do some testing to gather data before making more match .308 rounds. I may try to go later today. I've got about 200 more .45acp cases to run. Looks like I've got another week from H3!! coming at work this week but maybe I can get to those next week.
Full length sized 100 x Lapua 223 brass cases.
Swaged the primer pockets of 224 x GGG military 223 brass.
Loaded 28 .32 Mag with BE-86 and 100 Gr XTPs this morning. Shot them this afternoon. Shot well, but not great, may bump it up a hair and try again, need to try Sport Pistol & IMR Target as well.
Not one from this batch, but it looks the same.
I cast and coated over 40 lbs of 9mm bullets this weekend.
I have a few with #9 that I need to test, interested to see your results.
Built a new reloading bench and assembled the Loadmaster.
Wow, that's a deep bench! You must have long arms
I had same experience with the hf white. It shoots fine.
.40S&W fired into phone book.
Separate names with a comma.