Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

What to do...S&W 4006

Discussion in 'Handguns: Autoloaders' started by bolted_down, Jun 1, 2010.

Thread Status:
Not open for further replies.
  1. bolted_down

    bolted_down Member

    Joined:
    Jul 30, 2009
    Messages:
    12
    Hey everyone!
    Most of my 40S&W range work has been with a Beretta 96 up to this point.
    I've had a S&W 4006 for a while.
    Up until a week or so ago and 50 rounds down the tube, it was NIB-Never fired.

    It is a sweeeet pistol, as I'm sure you all know, and equipped with Novak lo profile sights.
    My problem is that Point of Impact is a good 3.5 inches below Point of Aim at 10-12 yds.
    At first I thought it was me...I put the 4006 down and picked up my XD...5 rounds sub 2" group at 12 yds.
    Nope, not my eye or my hand...picked up the Smith with a mag of WWB and Speer Lawman 165 gr and not a bad group, 2.5 - 3 inches, but again 3.5 inches low.

    I brought it home, rather frustrated with its performance.
    Dropped a boresighter into it and sure enough...the sights Point of Aim vs. laser line from the bore is off by about 3.5 inches.
    I see a set screw in the rear sight, but that does not appear to be an adjustment screw. ????
    Guess I'll be having an adjustable rear sight installed if I want POA/POI to match as they should.
    I can't believe S&W didn't catch the problem at the factory? Anyone else ever have a problem like this on a factory new pistol??

    Thanks for the read and any advice.
     
  2. jdh

    jdh Member

    Joined:
    Jan 5, 2008
    Messages:
    970
    Shoot some 180 gr loads in it and see where it hits. S&W tends to sight in for the heavier bullets.
     
  3. wow6599

    wow6599 Member

    Joined:
    Apr 6, 2008
    Messages:
    2,417
    Location:
    Wildwood, MO
    I've got a crisp $100 bill if you...........;)
     
  4. JWF III

    JWF III Member

    Joined:
    Jun 22, 2007
    Messages:
    1,183
    Location:
    Mansfield, Georgia
    If that doesn't work, install a shorter front site. Or a taller rear sight. (Front is usually preferred for a carry gun.)

    Wyman
     
Thread Status:
Not open for further replies.

Share This Page