Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Which parts should I get to maintain my buckmark?

Discussion in 'Handguns: Autoloaders' started by Fremmer, Feb 3, 2013.

Thread Status:
Not open for further replies.
  1. Fremmer

    Fremmer Member

    Joined:
    Oct 9, 2009
    Messages:
    2,284
    I have to order a new buffer for the buckmark, which got me wondering if there are any other parts or springs I could get to keep her running smooth. She's had a couple thousand rounds through her. Any suggestions?
     
  2. JoePfeiffer

    JoePfeiffer Member

    Joined:
    Jan 31, 2013
    Messages:
    180
    Location:
    Las Cruces, NM, USA
    That's the only part I can think of that I see consistent remarks about needing replacement.
     
  3. tuj

    tuj Member

    Joined:
    May 2, 2011
    Messages:
    1,983
    Location:
    Houston
    I'd pick up a spare extractor, those eventually can wear and get rounded off.
     
  4. wally

    wally Member

    Joined:
    Jan 2, 2004
    Messages:
    12,549
    Location:
    Houston, Tx
    If yours has the plastic sight base it will probably crack eventually. I managed to get an Aluminum replacement from Brownells but it also needed an intermediate piece and roll pin to reuse my rear sight.

    OTOH shot many thousands of rounds before the crack got to the point it interfered with function.
     
  5. Fremmer

    Fremmer Member

    Joined:
    Oct 9, 2009
    Messages:
    2,284
    Don't need a spare recoil spring?
     
Thread Status:
Not open for further replies.

Share This Page