Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

win 94 and williams peep sight problem

Discussion in 'Rifle Country' started by Zepo, Mar 9, 2009.

Thread Status:
Not open for further replies.
  1. Zepo

    Zepo Member

    Joined:
    Feb 25, 2009
    Messages:
    11
    Location:
    South Florida
    Hey all,

    Well i popped out the bull sight on my Winchester 94AE and put a marble 3/8 blank in there. so far so good. when I installed the peep sight which is the correct sight 5D-94se it seems I can't adjust it near its lowest setting without it scraping the breech bolt, any Ideas?

    thanks Zepo
     
  2. Onmilo

    Onmilo Member

    Joined:
    Jul 26, 2004
    Messages:
    9,773
    Location:
    Illinois`
    Yep.
    Adjust the site to the lowest setting that doesn't interfere with the bolt, then unscrew the little screw on the settings plate and slide the plate to zero, tighten the screw.

    Once you get your actual zero, in example, a 100 yard target zero, you can readjust the settings plate to reflect that setting as you actual zero setting. HTH
     
Thread Status:
Not open for further replies.

Share This Page