Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Winchester Model 250 Lever Action

Discussion in 'Gunsmithing and Repairs' started by Frankjm520, Jun 13, 2011.

Thread Status:
Not open for further replies.
  1. Frankjm520

    Frankjm520 Member

    Joined:
    May 30, 2011
    Messages:
    2
    I have taken this 22 apart except I cannot figure out how to remove the front stock. There was pin in the front plastic sight which I removed but the sight and magazine mount are one piece and it looks like the it is fitted to the barrel. Anyway, does anyone have any ideas on how to remove the front stock so I can refinish it?
     
  2. triggerman770

    triggerman770 Member

    Joined:
    Nov 30, 2008
    Messages:
    188
    Location:
    Conyers Ga.
    removal of handguard

    there should be a pin in the "sight mount" just above the magazine tube. drit this out and pull the mag tube out and the forend will come off. the tube holds it on the gun
     
  3. Frankjm520

    Frankjm520 Member

    Joined:
    May 30, 2011
    Messages:
    2
    That was it! Thanks for the help, now on to the refinishing.
     
Thread Status:
Not open for further replies.

Share This Page