Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Winchester recent production tang sight over tang safety?

Discussion in 'Rifle Country' started by Leaky Waders, Jan 5, 2010.

Thread Status:
Not open for further replies.
  1. Leaky Waders

    Leaky Waders Member

    Joined:
    Apr 14, 2003
    Messages:
    828
    Location:
    Content listed as posted by me may have been edite
    Hi,

    So I have an 1895 Winchester in 3006. It has a rebounding hammer and a tang safety.

    I purchased the rifle new about 10 years ago and got it out today to compare it to another rifle (post pending). Anyways, the freaking safety can move, but is stuck in the safe position preventing the hammer from reching the firing pin.

    Can I just have a gun smith replace the safety with a Marbles tang sight and be done with it?

    L.W.
     
  2. Strongbad

    Strongbad Member

    Joined:
    Aug 3, 2005
    Messages:
    692
    Location:
    Austin, Tx
    I don't think that'll do, but I can't be certain. Marbles makes a tang sight for the 95's with the tang safety.

    Compatible Tang Sight

    As an alternative, does your 95 have the two screws on the left side of the reciever, near the top/rear? If so, you're already pre-drilled for a reciever mounted peep. Some of them were drilled, some of them were not. Mine was not unfortunately. I ordered a peep from Lyman and had a gunsmith install it for me.
     
  3. eastbank

    eastbank Member

    Joined:
    Jul 30, 2009
    Messages:
    3,060
    i have quite a few brownings made in the 80,s and early 90,s before winchester started making them and i have not bought another be cause of the safety issue. i guess they are a good idea,i just don,t like them. eastbank.
     
Thread Status:
Not open for further replies.

Share This Page