Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Windage Adjt on 3rd Gen S&W Pistols

Discussion in 'Gunsmithing and Repairs' started by JNewell, May 31, 2004.

Thread Status:
Not open for further replies.
  1. JNewell

    JNewell Member

    Joined:
    Oct 1, 2003
    Messages:
    2,714
    Location:
    Land of the Bean & the Cod
    Specifically a 5943. Can the rear sight be drifted for windage without damaging all the plungers, springs, etc. in the aft of the slide?
     
  2. stans

    stans Member

    Joined:
    Dec 27, 2002
    Messages:
    2,426
    Location:
    central Virginia
    If I remember correctly, there is a plate that separates the bottom of the sight from the springs, so you should be fine to make small adjustments.
     
Thread Status:
Not open for further replies.

Share This Page