Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Wooden grips for the S&W 500

Discussion in 'Handguns: Revolvers' started by frankverrees, Jul 10, 2008.

Thread Status:
Not open for further replies.
  1. frankverrees

    frankverrees Member

    Joined:
    Feb 11, 2008
    Messages:
    21
    Hello,
    are there wooden grips for the S&W 500 for Sale?
    Thank you

    Frank
     
  2. xr7boost

    xr7boost Member

    Joined:
    Feb 17, 2008
    Messages:
    11
    Yup. Look for Jim Badger's grips domestically or the Nill grips from Deutschland.
     
  3. plinky

    plinky Member

    Joined:
    May 23, 2008
    Messages:
    284
    I believe that any grip that fits the K frame round butt frame will work on the .500. I put rubber Bantam grips on one. They are kind of small for the size of the gun but fit like a glove. I talked to Hogue about some fancy wood grips. The lady on the phone said they advised against it because of possible grip breakage. Could be a problem but I think they would install just fine.
     
Thread Status:
Not open for further replies.

Share This Page