Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WSAR-10 Trigger Slap

Discussion in 'Rifle Country' started by Will Learn, May 10, 2006.

Thread Status:
Not open for further replies.
  1. Will Learn

    Will Learn Member

    Joined:
    May 7, 2006
    Messages:
    481
    Friend just left his Romie while he's in the sandbox and I'm trying to fix this trigger up a little for him. The triggerpull gets real heavy towards the end of a 30rd mag, I've been told that this is trigger slap:( . Any help would be appreciated.
     
  2. XavierBreath

    XavierBreath Member

    Joined:
    Jan 6, 2003
    Messages:
    5,054
    Location:
    Louisiana
  3. Bartholomew Roberts

    Bartholomew Roberts Moderator Emeritus

    Joined:
    Dec 26, 2002
    Messages:
    14,613
    Location:
    Texas
    Trigger slap is where the bolt smacks the top of the cheap semi trigger as it slams the next round into battery. This causes the trigger to "slap" your finger as it resets.

    I am not sure what would cause a trigger to get heavier towards the end of a mag in the AK.
     
  4. MTMilitiaman

    MTMilitiaman Member

    Joined:
    Apr 28, 2005
    Messages:
    2,690
    Location:
    Missoula, Montana
    The cheapest fix is to spend 30 minutes or so with a Dremal as one of those links probably shows. The nest cheapest, quickest, and most effective is to simply put in a Tapco G2 trigger group.
     
  5. g56

    g56 Member

    Joined:
    Jan 17, 2004
    Messages:
    716
    Location:
    Oklahoma
    What Bartholomew said!
     
  6. Will Learn

    Will Learn Member

    Joined:
    May 7, 2006
    Messages:
    481
    Thanks for the help. I'm not sure if i'm describing the problem correctly (first time working with AK) Bartholomew but the cycle rate slows down considerably towards the end of a mag. I don't know if this is due to the trigger or not, but i do know my finger is getting a little sore towards the end of these 30rd mags. I really appreciate the advice and will try to make good ue of it.
     
Thread Status:
Not open for further replies.

Share This Page