Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

XS Shotgun Bead Sight Installation

Discussion in 'Gunsmithing and Repairs' started by Kjay, Sep 7, 2011.

Thread Status:
Not open for further replies.
  1. Kjay

    Kjay Member

    Joined:
    Dec 25, 2002
    Messages:
    162
    Location:
    Portland Oregon
    I'm planning on putting XS big-dot bead sights on two shotguns. The package as delivered from XS didn't contain directions or "glue." Anyone have advice as to what adhesive to use in attaching these sights onto the existing beads? Thanks!
     
  2. Carne Frio

    Carne Frio Member

    Joined:
    Aug 28, 2008
    Messages:
    745
    Location:
    Near Fairbanks
    Might want to get it from the horse's mouth:


    " Ask your question by emailing us at tech@xssights.com and one of our tech staff(Bo, Monte, Justin or Dave) will get back to you. "
     
  3. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
  4. oneounceload

    oneounceload member

    Joined:
    Apr 24, 2008
    Messages:
    15,710
    Location:
    Hot and Humid FL
    Are they threaded or crush-fit?
     
  5. Kjay

    Kjay Member

    Joined:
    Dec 25, 2002
    Messages:
    162
    Location:
    Portland Oregon
    I believe it's crush fit - you just glue the XS sight on top of it. I contacted XS - so far no reply. I do think I'll wind up using the "black" loctite. Thanks all.
     
Thread Status:
Not open for further replies.

Share This Page