Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Yugo M48A feeding issues

Discussion in 'Rifle Country' started by 50caliber123, Jul 25, 2007.

Thread Status:
Not open for further replies.
  1. 50caliber123

    50caliber123 Member

    Joined:
    Oct 31, 2005
    Messages:
    640
    I recently acquired a good condition, all matching parts M48A Mauser rifle. The problem I have is that the bolt head doesn't always (even when the bolt is cycled slowly) grab the rim of a round in the magazine, it just pushesthe round forward, only to get the round caught in the chamber, with the bolt unable to close fully. Anybody know how to remedy this? I have a K98 that works fine, so I know the 98 mauser action should be a controlled-round feed. Any help will be greatly appreciated, thankyou.
     
  2. Threejs

    Threejs Member

    Joined:
    Jun 25, 2007
    Messages:
    101
    Check to make sure there is enough clearance between the extractor, and the boltface. If there is not enough, the round will skip over it, and cause the problem you are describing. I would also check to make sure that there is not alot of crud under the extractor.
     
  3. cracked butt

    cracked butt Member

    Joined:
    Jan 3, 2003
    Messages:
    6,986
    Location:
    SE Wisconsin
    Take your extractor off and polish underneath the claw with a fine sharpening stone. Any burs or roughness in that area will cause the problem that you are having.
     
Thread Status:
Not open for further replies.

Share This Page