1KPerDay
Member
I have a few glocks but don't shoot them a LOT because I prefer my SIG and 1911s, mostly for ergonomic reasons. Recently I've been shooting my G23C with a new storm lake .40 barrel (not ported) and I discovered that the rearmost bump under the trigger guard was bugging me after a few magazines. So I sanded it down and it looks pretty good actually. And it seems to have alleviated the problem.
However, I'm getting my trigger finger pinched between the bottom of the trigger and the inside of the guard. I have the smooth trigger installed which fixed one issue but this is a new one. I've only noticed it shooting full-power factory loads through the non ported barrel. Any fixes recommended?
also a couple of times the slide locked back mid-mag. I tried to really concentrate on where I was putting my thumbs to make sure it wasn't being bumped. can recoil cause the slide stop to move up and lock? I have the Glock "extended" one (with the tiny little shelf) installed right now.
However, I'm getting my trigger finger pinched between the bottom of the trigger and the inside of the guard. I have the smooth trigger installed which fixed one issue but this is a new one. I've only noticed it shooting full-power factory loads through the non ported barrel. Any fixes recommended?
also a couple of times the slide locked back mid-mag. I tried to really concentrate on where I was putting my thumbs to make sure it wasn't being bumped. can recoil cause the slide stop to move up and lock? I have the Glock "extended" one (with the tiny little shelf) installed right now.