-Gadsden-
Member
Hello,
any advice or critique is appreciated.
-124 grain lead ZCast bullet
- 4 grains Unique powder
- 1.063-1.065 OAL (Lyman recommendation is 1.065)
I've taken a shot of the primer seating depth. From using the ruler gauge on my caliper, I found the depth to be about .006 deeper than the case head.
Also included are a picture of the round's headspacing. Based on this diagram: http://img651.imageshack.us/img651/3109/45seatingpossibilitiesx.jpg
the headspacing appears to be adequate.
The bullet shaved a little. Next time I will expand the case mouth a bit more. Is there anything detrimental about small shavings, just out of curiosity?
I ran the round through my Sig SP2022 -- the gun I'm building these reloads for. Cycled fine and there was no bullet setback.
thanks for your time! Please let me know if I need to include better pictures or provide more info
any advice or critique is appreciated.
-124 grain lead ZCast bullet
- 4 grains Unique powder
- 1.063-1.065 OAL (Lyman recommendation is 1.065)
I've taken a shot of the primer seating depth. From using the ruler gauge on my caliper, I found the depth to be about .006 deeper than the case head.
Also included are a picture of the round's headspacing. Based on this diagram: http://img651.imageshack.us/img651/3109/45seatingpossibilitiesx.jpg
the headspacing appears to be adequate.
The bullet shaved a little. Next time I will expand the case mouth a bit more. Is there anything detrimental about small shavings, just out of curiosity?
I ran the round through my Sig SP2022 -- the gun I'm building these reloads for. Cycled fine and there was no bullet setback.
thanks for your time! Please let me know if I need to include better pictures or provide more info