Neither - your concern is Reset. It is the forward movement after firing until it will fire again (not necessarily all the way forward to the where the trigger rests without your finger on it), as you stated. As for a trigger job - in my opinion you can adapt to any reasonable reset (assuming...
Some random thoughts on all this:
Every situation is different but many are overlaying their own environment on this event. You may be absolutely certain that all your family members would be awake, alert, and have acted and/or moved according to your plan (not a safe assumption in my opinion...
I compared a Warren Tactical sight on a Sig to a Warren Tactical sight for a 1911 to see what would give the same height of the notch above the slide for both. As the notch dimensions are identical I would think the height above the slide would be similar, but I am not going to proceed on that...
I'm still confused! I have attached a jpeg showing the measurement I need. I don't see that I can assume the front edge of the sight is flush with the slide or that I have a reference between the top of the slide and any part of the sight. I'm hoping there is a standard for the "S& W dovetail"...
Keeping in mind I'm a novice, that sounds like measuring the dovetail which we can do. It looks like there must be a notch cut out of the rear of the slide (with the dovetail extending below) and I don't know how deep that cut should be.
I have emailed Warren to see if the have the...
Another rookie question here. I bought a Rock Island 1911 in .38 super as a base gun for "do it myself" projects to become familiar with 1911s. One of my first projects is to replace the sights so I ordered a set of Warren Tactical sights for S&W dovetail and I plan to have a machinist/shooter...
Rephrase the question...
to "kill or no kill?"
Are their actions bad enough that, legally and morally, killing them is an acceptable and necessary response? The answer may well be "yes" but I feel it is important to be clear that shooting is not some righteous, romanticized response without...
Setting aim point?
How do you choose to adjust the laser relative to the sights? I just picked up a S&W MP340CT and it is a little disconcerting to have the spot match the sight at only one distance. I'm thinking I will either set it to match at a short distance or adjust the laser parallel...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.