I started my 18" middy build
Ruger lower for a something I didn't have and local
PWS Ratchet castle nut and endplate cause I thought it was a novel idea and wanted to try it out. https://www.primaryweapons.com/product-url-1893
Magpul CTR with grey Larue RISR because I had them
Seekins mag...
I feel like I may have been an engineer in a past life which causes me to enjoy looking and understanding machines now. I would certainly like to know more. I agree with the others that the cleaning of primer pockets may not be a huge selling point, now if it could clean the lube off after...
I've been reloading only since ~2010. After the first couple years I could not tell any difference between primers, all SPP seemed the same all LRP seemed the same. Because of this, and the fact that I preprime my brass, not only do I not record primer lot# but I don't record the primer brand or...
Prolly won't damage the die but may break the primer arm/seater. There should be enough room in the seater cup to push the primer out of the case though, just go slow.
I like to use the flash hole uniformer to get a nice cone shape for the primer to start the powder up. I dont think I can shoot well enough to tell an actual, on paper difference.
I might mag dump once in a blue moon. But rarely won't have targets....sometimes i am lazy and opt to not walk the target stand to rifle lengths and will blast at rocks.
I found a nice wood desk at Goodwill that i mounted my presses on. Of course, im lucky enough to have a girlfriend who doesnt mind our bedroom being in the living room and our one bedroom being the "reloading/storage" room.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.