Recent content by sweet betsys ike

Thanks to all that replied,[ Especially Archie ] . I think he may of had this done. I do remember he used a model 19, 4 inch as his main carry gun. The 15 is a snub nose, and was a back up. I guess if you are in a fire fight and your main weapon go's down or whatever, then you will still be...

Hi I have a model 15-3 serial #8K597** and it will chamber .357 magnum rounds. Every type of factory and hand loaded ammo I have tried drops right in flush with the cylinder. and the cylinder shuts with no problem. I found this out showing a novice shooter how .357 magnums are not suppose to...

My worse is a Smith&Wesson 1911 E series. Bought from Buds guns 5-10-12 When I first got it, shot so high and left wouldn't hit the target. Sent it to S&W Got it back after 3 weeks sill shot high and left, took it apart to clean it and the link pin fell out. Sent it back again still shoots left...

bad motor Just took mine apart and cleaned it up lower bearing lockup , freed it up and packed it with wheel bearing grease. Turns freely but it must have a bad stator, if you tap on the side of it , it sounds like a weed eater that doesn't want to idle. Oh well , may just have to brake down...

Hi everyone. My case tumbler motor went bad, it's out of a Frankford Arsenal. I'm looking to replace the motor if I can find one at the right price. The motor has a sticker that reads YJF61/26 120 volt E169323 W&W Motor Co. LTD . Anyone know where to get a replacement . thanks Ike

Hi everyone. My case tumbler motor went bad, it's out of a Frankford Arsenal. I'm looking to replace the motor if I can find one at the right price. The motor has a sticker that reads YJF61/26 120 volt E169323 W&W Motor Co. LTD . Anyone know where to get a replacement . thanks Ike