I just got the stand for the powder measure. I think it's goimg to be too high. Gotta figure something out. Clamped in the vise..... Brilliant, I think I'm overthinking this thing.
That's my deer processing area. I debone, grind, can, and cook in it. My reloading/ gun maintenance area is 5'-6"x 8'. My man cave kitchen on the other side is 4'-6"x8'.
Ya, the shelves help a bunch. I have a wood shop, so a few leftover pieces of birch ply and some dados was pretty simple. I am adding a center shelf above the dies.
Ya, I have to cycle the lee press up a bit to access the top drawer on the right. The Rcbs won't allow access to the top drawer on the left side no matter where you cycle it. I just don't keep anything in there. The mounts I made make it fairly easy to move things around if needed.
Does these pistol have a reversible mag release as well as ambi safety and ambi slide release? How's the finish hold up? I've heard that CZ finishes don't (with the exception of gloss blue).
I like to support the "little" guys.
I ordered mine (same kit) from here:
https://kempfgunshop.com//index.php?page=shop.product_details&flypage=shop.flypage&product_id=62&category_id=26&manufacturer_id=0&option=com_virtuemart&Itemid=41
Cheaper and you can even call and talk with a...
Which Missouri Bullet should I order for plinking loads? I do want something that groups well. But is a little less in the recoil dept. than most factory 44 mag loads. I think I'll probably load 240g XTP's for hunting rounds. BTW, I'm using H universal powder.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.