Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
You are using the old Black Responsive theme. We have installed a new dark theme for you, called UI.X. This will work better with the new upgrade of our software. You can select it at the bottom of any page.
Since that brass is useless to me and all appears to be in good condition, should i try and sale it, or just scrap it? It is roughly 300 pieces, so it could make someone really happy. Or would you guys think that it would be a "scam" to sale it? .300 WSM "once fired" brass is kinda difficult to...
Based on the info supplied, I'd wager that the once fired brass you purchased was fired in an oversize chamber and the bases are expanded beyond where your die will reach
What is an oversized chamber? Do they do this on purpose, or is it just the differences in manufactors?
It is not my brass, i bought it as "once fired" brass. My gun is a Tikka, not sure if that makes a difference. Tonight after work i will go home and take some measurments and post that...anything else that would be helpful to know that would make this easier to troubleshoot? Thanks for the help.
OK...I have a Lee aniversary press, with Lee shell holder and a RCBS full length resizing die but i keep getting a ring around the bottom of the case like it is not resizing the entire case??? If you look between the two red lines you will see the issue. The cases will not fit into my rifle and...
I have about 225 of these pieces of .300 WSM. The head stamp each says "Winchester .300 WSM". Are theses any different? The problem is that they will not even fit into my normal .300 WSM Lee shell holder. I noticed that they each have a gold/brass slot in the base...Any ideas?
For really tarnished brass (range pickups) I soak them in a solution of 1 cup, vinegar, 1 cup water, 1 tsp salt, 1 tsp regular dishwashing detergent for 15-30 mins (shake every 2 or 3 mins). Then I rinse them very good and throw them in wet into walnut (medium size) with a cap of NUfinish car...
Ok. This may sound stupid, but can you mold your own bullets out of lead with out jacketing them for high powered rifles...why or why not? Also what could you make solid lead bullets for? Just pistols?
I am pretty ignorant when it comes to this, so please don't laugh to hard!!:confused:
I bought a Lee Load Master to load .223. I am using H335 and it keeps spilling out of the powder measure on the side. (out of the drumm) which in turn makes it very hard to turn which is breaking the chain. Is that powder to small for the Lee "Perfect Powder Measure". Has anyone else had a...
load a 12 ga with a roll of dimes and shoot at a sheet of plywood and marvel the results...gets kinda expensive though and repeatedly done would wreck havack on your barrel...:o
...also there are a few sites i have found.
http://ammobrasstrader.com/forums/
ammobrasstrader.com is also going to start a ammobrassseller.com eventually. He mentioned it in his blogs
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.