Search results for query: *

Posted on perfectunion as requested.......... Jim.............

Well, after having shot and posted my results, I hope it does not stop there. I would like to see a lot more Mini and AR shooters get out there and shoot, then post. I see many posts saying what they can do on both sides, but don't see them posting any targets to back it up. Does not matter if...

What nalioth means by blind pinning is that both sides of the pin hole have to be covered by weld. This way the pin is non removable.. Jim...........

It is a 186 series, standard stainless Mini-14. Mods are as following: ACG barrel strut and clamps, ACG .060 gas port bushing, ACG Match Trigger which breaks @ around 3 pounds, front and rear buffers, Williams Foolproof rear target sight with the front sight narrowed to .070", the muzzle brake...

Hi all, My name is Jim. Heard about thehighroad at perfectunion.com by way of the Mini-14/AR-15 challenge. So I decided to take up the challenge. I am located in The Barstow area of the Communist Republic of California. I have been a gunsmith for over 43 years and am semi-retired and am also a...

Well I decided to take up the challenge. Went out and shot a little while ago. Both targets from bench @ 100 yards, 5 rounds each and both targets in less than three minutes. I used Winchester white box 5.56 55gr ammo as I did not want to burn up my match ammo. I heard of this challenge from...