Search results for query: *

Blue68f100, Did you drill / tap completely thru the press? In your picture it looks like the set screw is installed from the bottom in order to have crown of the screw at the top of the press... ........... Disregard the post.. just looked at my press and see the location at the bottom of...

Just called Hornady last week and spoke to Lonny in customer service. It looks like they have a real fix for the issue and have made a new aluminum funnel tube that accepts the large diameter plastic drop tube but internally is a narrower diameter to support the smaller 40 SW cases. Call...

Famous Hornaday Customer Service Let Me Down I called Hornady this week to inquire about the status of the custom drop tube one of their customer service reps told me they would build and send me to address the problems the Hornady case feeder has with some 40 S&W cases getting stuck in the...

I also called Hornady for a fix to the 40 SW case feeder problem and they said they would build a custom funnel that accepted the larger diameter feed tube but had the smaller diameter bottom opening. Its been about 2 weeks and I am still waiting and will update the post when it arrives. The...

Spent a few hours tonight taking the drop tube apart and re-assembled everything. I have working about 95% of the time, but still need to clear jams every 30-40 rounds. Better than last night, but still not working as well as it should

I just setup a Hornady Case Feeder on my LNL AP. I immediately ran into problems with the .40 S&W brass getting stuck in the small drop tube. Reread the directions and saw there is a note that .40 SW brass my require using the large drop tube and funnel assembly. After the switch out, the...