Search results for query: *

anyone use them? they are considerably cheaper than pretty much anything else i have found. i tried searching here and google, with no hits. they advertise ar500, but we all know that isnt always the case.

http://imgur.com/a/6tE71 i ordered 500 pieces of 7mm rem mag brass, and 336 of them have a ring indicative of being used in a pressure test barrel. on some of them, the ring can be seen on the inside of the case, but i couldnt get a good picture. are these safe to use?

Has anyone used this combo? Any load data? That's the powder I have on hand, and the local shop is pretty dry on powder; just a few magnum rifle powders left. For 44 mag

impossible meaning, when they are assembled, they wont chamber

aa hulls, claybuster waa12r replacement wads. i approximated the powder charges, because the recipes in my lyman manual are impossible.

just thought, i am doing the standard 8 pellets in a 2 3/4"

just started loading buckshot for the first time. have a 5 lb box of 00, and a 5 lb box of 000. with the petals cut off of a wad, i can get the 00 to fit nicely, but the 000 still wants to bulge enough to make the round stick sliding into the chamber, just a little bit. are they safe to fire...

thanks. it fits in the chamber by 1/16 or so, but it does fit

its a 125 grain cast bullet with 7.6 grains of unique. about halfway between the starting and maximum load

...to fire a .357 magnum with the bullet crimped .135 too far out of the case? just got the gun, and was attempting to set up the dies. still new(ish) to loading. its crimped in the lube, rather than the ring where its suppose to crimp. my concern is underpressure. my kinetic puller doesnt...

i have the manual, and have read that part of it. the problem is that it is taking quite a bit more than a "tap". am i just being a pussy about it?

I have the vertical sight adjusted, but cant seem to drift the rear sight to adjust horizontally. it seems to be stuck. is it ok to drift the front sight? any advice for the rear?