I got a nice 10 point rack at a garage sale that had been coated with polyurethane. I used paint remover to take the poly off and the antlers turned white . Any body ever tried coloring antlers before? Alot of knowledge in this forum.
Tim
I work for the WI Departmant of Corrections. I've worked in every classificaion from minimum to maximum and juvies. After 24 years I am a bit salty. There are people that are born bad. There are also good people who make bad mistakes. There are consequences for our mistakes and some good...
I tried seating the bullet 1/2 way then rotating it and seating it the rest of the way. Didn't help. I checked the price of the concentricity guage and I wish I knew some one who had one I could use. Back to the gun smith. But if my chamber isn't straight with the barrel and that is...
Tom,
I'm using a Redding Die set. I also have a Lee. They both do the same thing as far as seating. The Redding set does leave a smother case neck. I'm using Hornady 139 gr. Interbond and Interlock and 140 barnes. All with the same results.
Before I can go with a case...
Thanks, I tried the magic marker. I didn't see any point where I could say the case was sticking. And I don't use the bolt to remove the shell. I push a dowel down the barrel. I didn't feel any real resistence when I push the shell out. I suspected my bullets are not seating straight. How...
Same side of the bullet. If my cases were out of round, I wonder, would that cause it. I bought a second set of dies and same thiing. Even factory shells stick. Why do people turn the outside of their case necks.?
I need some help. I have a Ruger M77 .280. I had it rebarelled with a match barrell and what the gunsmith said was a good reamer. Same caliber. Now my reloads stick in the chamber. I was determinining bullet seating depth and discovered it. I push a reloaded round into the chamber and push...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.