Its a 2.5 inch barrel. I had to sand the grips until they would clear around the trigger guard and now they fit ok. Thanks for all the replies and help!
"How off is it? Sometimes wood grips need to be fitted a little bit."
This could be it. I have another round but K frame I am going to pull the grips and compare.
2" barrel pinned and recessed. Target hammer and trigger. Its a round but. I thought ahrends K\L frame grips would fit it for sure. It just does not line up with either grips I have tried.
I acquired a model 19-3. It came with overmolded aftermarket grips. I want to put some different grips on but neither of the grips I have tried want to fit correctly. I tried some S&W K frame round but grips but they don't fit. I bought some ahrends grips to put on there they don't fit either...
Get the Colt CCO. They are hard to find but out there.
STI Ranger is a good second choice.
Otherwise a Kimber Compact series I is a good third choice.
All have the short grip and 4" barrel.
I might get corrected on this one, but I fear the mink oil you used caused the stretching of the leather.
Sometimes completely soaking the leather and letting it dry will cause it to shrink.
Someone else here might chime in...
Mike
Yes I googled the address and got the same.
I did not put too much into that as I have stuff sent to work.
First bad gun deal in 20 odd years.
This guy got insulted when I was persistant in asking for tracking numbers thats what made my radar go up.
I sent the guy a cashiers check drawn...
I had a guy in Cuyohoga Co. take some money from me and never send me the gun or return the money. I am filling a police report but...
I was hoping to find a sympathetic attorney or law enforcement officer to help leverage my case.
Just working the angles,
Mike
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.