• You are using the old High Contrast theme. We have installed a new dark theme for you, called UI.X. This will work better with the new upgrade of our software. You can select it at the bottom of any page.

Search results for query: *

  1. F

    shoulder bump in .223 AR

    Gun: 20" Wilson barrel with Wylde chamber RRA Ar-15. Load: 69 smk with 25.3 Varget at 2.260 oal. Shoots 0.8-1.2 moa at 100yds, but about 2-2.5 moa at 300 yds. I've been using a FL Lee die set up the way the instructions say to, screwed down until it touches shell holder and then another...
  2. F

    223 and wind

    I've just started playing with a 223 lately. I was playing around shooting at 150-200 yards with some serious wind (30-40 mph at my 3 oclock). Shooting a 20 inch rock river predator upper with 69 grain otm ammo. Ballistic calculations say bullet travel should be 4 inch drop and about 15...
  3. F

    help with choke id

    I had a glenfield 788 12 guage drilled and tapped for choke tubes 15+ years ago. Gunsmith included 3 chokes with it. I know those guns are cheap and not feasible for spending money to upgrade but it was a family hand down that I wanted to make usable since it was fixed full choke. Anyway...
  4. F

    duracoat color question

    I am aboout to refinish an old beat up marlin 336 lever 3030. Trying to decide color. I just did a ruger 10/22 in duracoat gun blue color. I'm happy with it, but the color is not as dark as "gun blue". It has a much brighter blue color to it. I was thinking about mixing duracoat gun...
  5. F

    federal ammo customer service

    I bought some federal shotshells, 3 inch BB non-toxic last year (the fourty bucks for 10 shells kind). When I went to use them later I noticed the crimps were poor and you could see shot (not good for a waterproof waterfowl load). It had been a few month since I bought them so I didn't mess...
  6. F

    dura coat degreasing question

    I am about to do my first dura coat project on a ruger 10/22. I have read tons of stuff and feel prepared to have a go at it except one final prep question. I know to degrease throughly, but my question is in regards to degreasing with clay in the holes/areas you don't want spray to go...
  7. F

    rem 700 trigger adjust

    I have an older remington 700 cdl .270 (approx 12 years old). I have kept it 100 percent stock all that time but have decided to start tinkering with it. I was thinking trigger first, pillar bed second, action bed third. I have tinkered my ruger 10/22 to death (very successfully too) and am...
Back
Top