same thing here but I ordered the RCBS one and I don't know why I didn't get one a lot sooner it is great fast and right on the money hope you enjoy yours too everybody have a good new year
I carry both 38spec and ppk/s I feel the 38 has a more punch to it and feel the simply operation of the revolver makes it the better choice
but I dp agree carrying speed loaders is more bulky over the extra magazine for the.380 acp
so I will have to say there is pros and con to every...
I picked.....Much harsher and swifter punishment for the convicted
they don't enforce all the current laws....we don't need any new ones or ones directed toward lawabiding.good people who are not bothering anyone
"In my eyes, it's all about knowing when you are likely to get caught off guard and being prepared for it so you aren't... "
.............................................................................................................
yes I carry except like going to the doctor for example but...
I always used a10/10 balance scale the 2 weeks ago I don't know why I put the test weights on it to check it and it wasn't reading correctly then I tried the weights on a cheep digatile scale and that read correct
what do I do but toardes the end I tiered it and it was wrong checked going...
are you reloading on a progressive press ? do you have the right shell plate for 9mm I am loading9mm now ...well not this min now im typing...how is your timing on your press ..could a adjustment help....hope you figure it out ..9mm is easy to load
I have a polychoke on my 20 ga browning I have had it since I was a teenager
I have always loved it its not bulging like was said I must have an older one maybe 60s or 70s it has been my favorate small game shotgun.
you just move it a click or 2 and you have tighten or open up the spread...
I almost sure its not a P-38 holster I have one an original one its not to like you" rcmodel " not to know im sorry I could not help and thank you for all the great help for all those members you have given ....I always trust your knowlge thank again for all the help it looks...
when I 1st started I trimmed the cases after sorting them because the "books" said to do it.....then reading and comparing different educated members on here that I respect their wisdom....rcmodel +walkalong for two examples ...also what I learned when hands on doing I relised it wasn't going...
hachaduryan 1st welcome as a new member more or less and it seams you figured out it was the brass case when something happens don't worry get out your tools and measure...test in other case etc you will find its not too hard and get the hammer type bullet puller you can reuse the parts again
swap them .... they could come in handy push comes to shove you run out of large primers .... I understand that you have to keep them separate and an extra step in the sorting sorry I didn't come up with the idea
I belive it is an over charged load check your loads ...go back to the books not just one look at a few different listings and compaire to your load ..don't shoot any more till you figure out the cause bad things can happed quickly
I weigh everything when trying test loads to see what works for my gun
then after finding the right load I set the press getting it right and as I go I check it every so often to see it stays there
you must start at min and work up carefully you don't want to get hurt and blow up your...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.