Search results for query: *

Evidently no. I shot a nice group about 2.5 inches high of the point of aim (tip of the front sight) at 15 yards. Hickok45 also commented on the 6 o' clock hold during his review of the full size p320, so for the most part I expected this. From what I understand it takes p226 sights so...

I just purchased a 9mm Compact p320 last week and had a chance to put 50 rounds through it yesterday. I like it a lot. Similar size to the G19 with slightly more weight. Grip feels great, grip angle works better for me, recoil is very light, the trigger is quite nice and the gun seems...

Checkmate link for the 8 rounders: Please note they are extended mags. Flush fit 8 round magazines; in my opinion, aren't optimal. http://www.checkmatemagazines.com/cart/pc/viewPrd.asp?idcategory=12&idproduct=112 Really though, a good cleaning would probably help a great deal.

I am a true believer in Checkmate's 7 and 8 round hybrid feed lip magazines. If my 1911 won't run right with those I usually start looking elsewhere for a problem.

I am going to go out on a limb and say you have other similar rifles to shoot? I would probably display it as P.B. Walsh mentioned. Beautiful rifle!

Great to hear! I must say I do like our state a great deal. It is encouraging to hear of our LEOs respecting ours rights! After all it is their rights too.

I found that to be true if i didn't go nose to charging handle. But when shooting with irons I tend to do that. It made a big difference for me with NTCH.

I run a YHM .30 cal Phantom on a 16" AR with a carbine gas system. The "puff" of blowback gas is annoying out of the charging handle but was mostly fixed with a gas buster charging handle. I also switched to a H3 buffer which works fine both suppressed and unsuppressed. Ejection is slightly...

Both would be very effective at close range (inside 20 yards). Federal flitecontrol buckshot extends that effective range of buckshot to ranges outside of the traditional useful range of buckshot, but it seems to only exist in 12 gauge ammo. I recognize that the AR15 is probably "the best"...

Temperature has the greatest effect on the speed of sound in air. The speed of sound in air at 80° F is 1139 fps The speed of sound in air at 0° F is 1051 fps http://www.sengpielaudio.com/calculator-speedsound.htm I have read that a bullet that is supersonic puts out approximately...

For what I do these days I use two powders: HP-38 (W231) for my pistol shooting H4895 for .223 and .308 loads HP-38 was changed over to from unique because of how it meters H4895 is used in my .223 loads because my rifle loves it under a 55 grain bullet. I am not generally after extreme...

As of Saturday morning Cabela's in Hamburg had CCI small pistol @ $40/1000. Since I was completely out I picked up 2k. I think they have a 2 box limit posted but I couldn't say if they are actually enforcing it. They had tons of Federal Large Pistol. Looks like local retailers are...

I'm a big fan of the LC9 I own. I see no logical reason why the LC380 isn't an excellent gift for your wife. If the 9mm has a bit too much recoil the .380 should fit the bill. My fiance is a big Ruger fan too, I don't think there is a Ruger firearm made that she didn't like.

I have been hit with ricochet squarely in the lens of my safety glasses while shooting at AR500 steel. It happens and isn't a big deal if you have safety glasses on. Do not ever shoot steel without safety glasses!

I worked up a 9mm load recently using Federal small magnum pistol primers. Not because that's what I prefer to use, but because that is all I have available to me at this time. I started low and worked up to the power factor I want. They shoot great and the load is accurate. Start low and...

Very nice! Thanks Sam.

To have a steel target that will survive shooting rifle rounds you will need to have at least AR500 target faces. Even then the closer you are the shorter the safe life span will be of the target face. Some rounds will do more damage then others, 62 grain green tip 5.56 seem to do quite a...

That must have been a heart breaking day out on the water. :neener:

fwiw in this USA today article it mentions his name briefly. http://www.usatoday.com/story/news/nation/2013/01/28/newtown-shooting-legislative-subcommittee/1870581/

Length of pull is adjustable from 13" - 14" using spacers that are provided. Which allows me to get my 13.75" lop that I prefer.