Search results for query: *

My holster finally came in (was backordered). It's a Galco CON-158B for my 642-2 with Crimson LG-405 Laser Grips. It's fits like a glove (pre-formed and the barrel extends to a perfect 1/4" from the bottom). It also wears very close to your waist. I use this same holster for all my carry...

Cylinders do line up nicely, no end-shake, with a gap much smaller than a credit card (probably about .003 at most). However, I do get a little cylinder side to side wiggle (slight). Does your 642 fully lock the cylinder with the trigger held firmly back?

I noticed my lastest box of USA .38 (standard pressure) FMJ rounds from Wal-Mart (130gn) have flat tops. I recall my previous ammo under the same label had a rounded head. Even the Winchester site http://tinyurl.com/23kvyv shows the .38 USA FMJ round with a rounded head, not flat. Any...

Does the rubber plunger at the end of the hammer strut go cone shape up or cone shape down?

What is the difference? Thanks.

With the cylinder swung out, the back edge touches the frame slightly.

S&W 4513TSW. Having feed problems. When a new round is ripped from the magazine, it should slide up and under the extractor. Sometimes I get a round that slides up but gets in front of the extractor. When the slide tries to close, it does not go fully into battery as casing head is between the...

Recently, I started having a failure with my S&W 4513TSW. After it goes bang, the casing ejects just fine, but when the slide moves the next round into battery, the back of the casing (on the new round), sometimes will end up on the *wrong* side of the extractor (towards the barrel), instead of...