Search results for query: *

Hey, Thanks all! I got it figured out. I just had to pull a bit harder than I was. It turns out that the outer part of the turret (the part that has the markings) comes completely off, and then you reset it back on at the 0/12 mark. The manual made it sound like it just popped up a bit and...

There is not two screws on it, and it won't move down at all. I guess I'll take it to a local gunshop I know and see if they can figure out what's going wrong. Does anyone else have any specific experience with this kind of problem? RecurveArcher

I have a Nikon Buckmasters 3-9 power scope. My question is regarding something that the owner’s manual says to do after zeroing the scope. (By the way, the finger adjustable turret is marked with ¼ moa graduations, with 12 moa of adjustment per turn of the turret. The 0/12 mark is designated as...

Thank you for your help. Are the remington sights any good in your opinion? Is it possible to use a scope with them? What is the best way? I assume you'd either have to use really high rings, see through rings (both of which I detest) or do the rear sights mount far enough forward to clear the...

I have a Remington 700 sps rifle, factory barrel, chambered in .308. It is the standard hunting weight contour, but it does not come with iron sights. I was wondering if it were possible to have a gunsmith install the standard remington factory sights, or any similar sight for that matter, to my...

Thank you for your informative and encouraging replies. I really appreciate it. To clear up any confusion, I meant my zero is 35 MOA from the very bottom of adjustment. So roughly half way up the entire elevation travel. I was only a few MOA away from mechanical zero, so I don’t think that...

Hey all, I'm relatively new to the rifle world, having bought a Remington 700 SPS in .308 a few months ago. I topped it with a Nikon Buckmasters BDC 3-9X40 scope, sighted it in, and went hunting. Now that summer and recreation are on my mind, I'm wondering how far I can realistically target...

Hello all, I recently bought a Remington 700 SPS .308, and I have a few questions about the tightening procedures for the action screws. Remington does not specify any particular tightness for the 700 action screws, although they do have a procedure for the 770 in their manual. I have heard...

I just watched the Bourne Ultimatum, and besides being an absolutely fabulous movie, I had a question that I thought some of you guys on THR could answer. What kind of monocular did Bourne have when he was watching the evil CIA guy from across the street. It seemed to be zoomable, and about 3-4...