"Drilled and tapped from the factory" where? Under the sight or on the top strap? I would like to put a small red dot on a 586. Any suggestions? Thanks.
If your 586 is a -4 or -5 it should be factory drilled and tapped. An earlier model will require a gun smith to D&T for the Weigand mount, or use a no gunsmith mount from someone like B-Square. Two of the three screw holes are visible by just swinging out the cylinder and looking at the underside of the top strap.
I really like the Weigand mounts, and use them exclusively on all my optics mounted guns.
Just loosen (raise) the rear elevation screw until it almost comes out of the sight body. Remove the front screw, then slide the whole sight assembly off the back of the frame.
You can unscrew the elevation screw all the way out, to make it a little easier to see what is going on with the hidden spud, but it really isn't needed.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.