Change fibers optic (easy way)
- Thread starter Mark_Mark
- Start date
- Status
jmorris
Member
- Joined
- Sep 30, 2005
- Messages
- 24,324
First cut the fiber in half and push each side back out of the sight.
Take a flame and ball one end of your fiber optic.
Thread that through the sight.
Clip the end off leaving enough to heat to another ball, so it can't back out.
Hit that end with the lighter and you are done.
Take a flame and ball one end of your fiber optic.
Thread that through the sight.
Clip the end off leaving enough to heat to another ball, so it can't back out.
Hit that end with the lighter and you are done.
OP
OP
Mark_Mark
Member
- Joined
- Jan 9, 2021
- Messages
- 18,151
doubleh
Member
Correct but I have only used a BBQ lighter turned down to a low flame for heat. Since I don't smoke that is the only type of lighter I have.
OP
OP
Mark_Mark
Member
- Joined
- Jan 9, 2021
- Messages
- 18,151
that’s what I have, smoke cigars on a full moon
doubleh
Member
The only way i would touch a cigar is to throw it in the trash. I quit smoking in 1972 and tobacco smoke of any kind makes me start wheezing and it becomes difficult to breathe. I have had asthma long as I can remember. Don't now why it didn't bother me back then but it sure does now.
OP
OP
Mark_Mark
Member
- Joined
- Jan 9, 2021
- Messages
- 18,151
Don’t blame you! it’s very dangerous
stop smoking cigarettes after my high school sweetheart left for college and left me. Needed something I could control in my life. Just once every month for me
Obviously the question was answered in the first response and the thread drift has been dramatic since then...no sense it letting it go further
- Status
