I am forming 17 FB brass from NEW 221 FB brass. However, after my process of forming the brass, the brass will not chamber in my rifle...I can chamber factory 17 FB ammo and 17 FB fired brass.
This is the process I am using to form the 17 FB brass:
I take 221 FB brass and lube with imperial lube
Run the brass through a Redding #1 17M4 Form Die
Then, run the brass into a Redding #2 17M4 Trim and Form Die
Finally, run the brass into a Redding 17 Fireball Full Length Sizer Die.
What am I missing?
Please HELP!
This is the process I am using to form the 17 FB brass:
I take 221 FB brass and lube with imperial lube
Run the brass through a Redding #1 17M4 Form Die
Then, run the brass into a Redding #2 17M4 Trim and Form Die
Finally, run the brass into a Redding 17 Fireball Full Length Sizer Die.
What am I missing?
Please HELP!