ForneyRider
Member
Of 200 count of once-fired .223 brass for 30$:
Most were Remington headstamp, small bunches of LC and Winchester. The rest were FC(about 20).
The FC brass were pretty short. The 26gr of Varget was at the base of the neck. After full-length sizing, they were all shorter than 1.75. I hear a lot of complaints about this brand. Should I just use this brass for plinkers?
From all the complimentary things I hear about the Remington .223 brass, I will make this my hunting/target brass. Appears to me, that the Remington has more capacity than the FC. I haven't loaded any of the Winchester or LC, so not sure of their powder capacity.
I full-length sized all this brass, trimmed where necessary, and chamfered the case mouth. I will try neck-sizing down the road.
Most were Remington headstamp, small bunches of LC and Winchester. The rest were FC(about 20).
The FC brass were pretty short. The 26gr of Varget was at the base of the neck. After full-length sizing, they were all shorter than 1.75. I hear a lot of complaints about this brand. Should I just use this brass for plinkers?
From all the complimentary things I hear about the Remington .223 brass, I will make this my hunting/target brass. Appears to me, that the Remington has more capacity than the FC. I haven't loaded any of the Winchester or LC, so not sure of their powder capacity.
I full-length sized all this brass, trimmed where necessary, and chamfered the case mouth. I will try neck-sizing down the road.