I just recieved a set of meprolights for my CZ75B. Would like to try and install them myself.
Front sight is dovetailed in from the front, and it looks like there's a pin holding the stock sight in. New Meprolights do not appear to have a slot to accomodate said pin. Is it a friction fit, or should I mill out an appropriate relief in the new front sight so the drift pin will go back in?
Rear sight looks to be a dovetail friction fit. Do I need anything other then brass hammer and punches?
Any advice appreciated!
Front sight is dovetailed in from the front, and it looks like there's a pin holding the stock sight in. New Meprolights do not appear to have a slot to accomodate said pin. Is it a friction fit, or should I mill out an appropriate relief in the new front sight so the drift pin will go back in?
Rear sight looks to be a dovetail friction fit. Do I need anything other then brass hammer and punches?
Any advice appreciated!