elkaholic1
Member
- Joined
- Feb 3, 2008
- Messages
- 34
I have a Rem 700 laminate stock where the barrel does not sit center in the barrel channel. The barrels is free floating with no pressure points but the gap on one side is twice the width of the other side. It's pretty noticable to because the barrel chanel almost looks like it was cut for the next barrel size up, so the gap is noticable. I think it's the screw locations because when you drop barrel and receiver into the stock it sits almost center. By the time you get them tightened up the barrel is off center. Would pillar and/or glass bedding the action correct this?